User manual

page | 18
Using the Web Interface
1. Access the Web interface by entering the IP address of the desired Sender or
Receiver unit. Refer to (Displaying the IP Address and Video Channel) if necessary.
2. Click the Network tab. The current channel is displayed within the Network Mode
window group.
3. Click the Channel Selection drop-down list and select the desired channel.
Channel numbers can range from 0 to 255.
4. Click the Save button on the right-hand side of Network Mode window group.
5. The following message will be displayed, at the top of the page, indicating that the
casting mode has been applied to the Sender or Receiver unit.
6. Access the Web interface of the next unit (Sender or Receiver) by entering its
IP address.
7. Repeat steps 2 - 5 for each Sender and Receiver to be changed.
Basic Operation
Operating the DVI KVM over IP with Local DVI Output