User manual
page | 30
USB under Unicast Mode
When connecting USB devices to the DVI KVM over IP with Local DVI Output, the
functionality is similar to that of video and RS-232.
As an example, we will start with our original diagram and connect a computer to Sender
unit S2 and a keyboard and mouse device to Receiver unit R2. This will allow us to control
the computer from the Receiver unit. Although we can connect up to 4 USB devices to
each Receiver unit, we will use only use a keyboard and mouse for this example.
In Figure 2.9, the DVI Out arrowheads have been removed for purposes of clarity.
Figure 2.9 - Using USB devices under unicast mode.
1. Make sure the desired Sender and Receiver units are set to unicast mode. Refer to
Conî‚¿guring Unicast Mode if necessary.
2. Access the Web interface for the Sender unit.
3. Click the Functions tab.
4x USB devices
LAN
Receiver unit
Receiver unit
USB cable
Computer
Sender unit
Sender unit
Sender unit
DVI In
DVI In
DVI In
07
07
02
05
09
R
1
S
1
S
2
S
3
R
2
USB Control
NOTE: By default, the DVI KVM over IP with Local DVI Output
Sender and Receiver units are shipped in unicast mode.
Operating the DVI KVM over IP with Local DVI Output