User manual

page | 34

Assigning USB control under Active per request mode

Now, let’s look at an example of switching USB control between two Receiver units.

Using the diagram on the previous page, we want Receiver unit R1 to have USB control.

To assign USB control to another Receiver unit, use the following steps:

1. Press and hold the -/Select button on the desired Receiver unit, for at least two

seconds. In this example, we will depress the -/Select button on Receiver unit R1.

2. The message “Starting USB” will appear on the connected display.

Figure 2.11 - Receiver unit R1 has USB control.

3. In order to assign USB control to a different Receiver unit, repeat steps 1 - 2

LAN

Receiver unit

4x USB devices

USB cable

Sender unit

DVI In

IMPORTANT: If switching between Active per request mode and

Active on link mode, the Save and Reboot buttons must be clicked

to apply changes.

Operating the DVI KVM over IP with Local DVI Output

USB Control