User manual

page | 38
Audio works in both unicast and multicast modes. To illustrate how audio works with the
DVI KVM over IP with Local DVI Output, we will set up an audio source (computer) and
some powered speakers.
Connect a 3.5mm-to-3.5mm mini-stereo cable from the Line Out jack on the
computer’s audio card to the Line In jack on the Sender unit.
Note that any audio device (e.g. MP3 player, etc.) can also be connected to the
Line In jack on the Sender unit.
Connect the powered speakers to the Line Out jack on the Receiver unit,
using a 3.5mm-to-3.5mm mini-stereo cable.
In unicast mode, the audio signal (connected to the Sender unit) will be distributed to
the Receiver unit that is set to the same channel as the Sender unit. Refer to Figure
2.12 on the next page.
In multicast mode, the audio signal (connected to the Sender unit) will be distributed to
all connected Receiver units that are set to the same channel as the Sender unit.
Refer to Figure 2.13 on the next page.
Connect to Line Out
on computer
Sender unit
Audio Connections
Connect to computer
speakers
Operating the DVI KVM over IP with Local DVI Output