User manual

CONNECTING THE DVI RS232 EXTENDER

1. Connect the DVI source to the DVI RS232 Extender sending unit’s DVI input

port using the supplied DVI cable.

2. Connect the RS-232 source to the DVI RS232 Extender sending unit’s RS-232

input port using the supplied DB-9 serial cable.

3. Connect the DVI RS232 Extender sending and receiving units together using

two user supplied CAT-5, CAT-5e or CAT-6 cables.

NOTE: If ﬁ eld terminating network cable, please adhere to the TIA/EIA568B

speciﬁ cation. Please see page 12 for more information.

4. Connect the display to the DVI output port of the DVI RS232 Extender

receiving unit using a user supplied DVI cable.

5. Connect the RS-232 device to the RS-232 output port of the DVI RS232

Extender receiving unit using a user supplied DB-9 serial cable.

6. Plug the 5V DC power supply into the DVI RS232 Extender sending unit.

NOTE: In most scenarios, the 5V DC external power supply for the receiving

unit will not be required. Operational power is supplied by the sending unit via

the connected CAT-5, CAT-5e or CAT-6 cable. If the power LED indicator on the

receiving unit is not on, please check to make sure that the RJ-45 cables are

not crossed (DDC to video and video to DDC). At extreme distances, it may be

necessary to apply power to the receiving unit.

7. Power on the display. Power on the source.

EXT-DVIRS232-CAT5N

DVI CABLE

RS232 CABLE

CAT5E CABLE (2X)

(Up to 300 ft)

Sender

Computer

Receiver

Touch Screen Monitor

Computer

Touch

Scre