User manual

page | 5
Introduction
ID Name Description
1 IR In/Ext Connect the included IR Extender to this
port. Alternatively, connect a mini-mono
3.5mm cable from this port to the output of
an automation system with an electrical IR
output.
2 LAN Connects the Receiver unit to the network (or
directly to the LAN port on the Sender unit)
using an Ethernet cable. See the next page
for installation instructions.
3 Reset Press this button to reset the Receiver unit.
See Performing a Factory Reset (page 5) for
instructions on restoring the Receiver unit to
factory-default settings.
4 5V DC Connect the included 5V DC power supply to
this locking power receptacle.
5 Power This LED indicator will glow bright green
and will remain illuminated as long as the
power supply is connected to the Receiver
unit.
6 Link This LED indicator will glow bright amber
to indicate that the Receiver unit is
communicating with the Sender unit.
If this LED is not illuminated, inspect
the connection between the Sender and
Receiver unit.
7 HDMI Out Connect an HDMI cable between this ports
and an HDTV display.
8 RS-232 Connect the included 3.5mm mini-stereo-to-
DB-9 (male) adapter to this port. Connect an
RS-232 cable from the adapter to a display
or other RS-232 device.
9 IR Out Connect an infrared IR emitter (Gefen part
no. EXT-IREMIT) from this port to the IR
sensor window of the source.
Getting Started