User manual

page | 6
The HD over IP w/ RS-232 and 2-way IR Sender and Receiver units can either be
connected over a Local Area Network (LAN) or they can be directly connected to one
another.
Using a Direct Connection
By default, Sender and Receiver units are shipped in Auto IP mode. In Auto IP mode,
each Sender and Receiver unit assigns itself a unique IP address within the range of
169.254.x.x. Auto IP mode is used only when Sender and Receiver units are directly
connected to one another. When connecting to a network, the Sender and Receiver units
must be set to either DHCP or Static IP mode. See Setting the IP Mode (page 22) for
more information .
1. Connect a CAT-5e (or better) cable from the LAN port on the Sender unit to the
LAN port on the Receiver unit. The cable should not exceed 330 feet (100 meters)
in length.
Figure 1.1 - Directly connecting the Sender and Receiver unit
2. Use the included HDMI cable to connect the Hi-Def source to the HDMI In port on the
Sender unit.
3. Connect an HDMI cable from the HDTV display to the HDMI Out port on the Receiver
unit.
4. See Additional Connections (page 8) to complete the installation process.
Installation
Power
Link
5V DC HDMI In
RS-232
IR
Out
HD over IP S
w/ RS-232 and 2-way IR
IR In/Ext
LAN Reset
EXT-HD2IRS-LANS
Gefen
Power
Link
5V DC HDMI Out
RS-232
IR
Out
HD over IP R
w/ RS-232 and 2-way IR
IR In/Ext
LAN Reset
EXT-HD2IRS-LANR
Gefen
Sender unit
Receiver unit
Getting Started Getting Started