User manual

page | 8
3. Set the desired network mode (DHCP or static). Refer to Setting the IP Address (page
24) for instructions on setting the network mode.
4. Repeat steps 2 and 3 for the Receiver unit.
5. Once the IP addresses have been assigned, disconnect the Sender and Receiver
units from the router and connect them to the network.
6. Follow steps 2 - 4, under Using a Direct Connection (page 6). to complete the
installation process.
Additional Connections
► IR
1. Refer to the section entitled Bidirectional IR Control (page 12) for details on
connecting IR devices.
► RS-232
2. Connect the mini-stereo-to-DB-9 (female) cable adapter from the RS-232 port on
the Sender unit to a DB-9 cable. Connect the DB-9 cable to an automation system.
3. Connect the mini-stereo-to-DB-9 (male) cable adapter from the RS-232 port on
the Receiver unit to a DB-9 cable. Connect the DB-9 cable to a display or other
RS-232 device.
► Power
4. Connect the included 5V DC locking power supplies to the 5V DC receptacle on the
Sender unit and Receiver unit. Do not overtighten the locking connectors.
5. Connect the included AC power cords from the power supplies to available electrical
outlets.
Installation
Getting Started Getting Started