User manual

Setting the Video Channel
In order for Sender and Receiver units to communicate with one another, they must both
be set to the same video channel. This is similar to changing the channel on a cable or
satellite box in order to view a different program. By default, all Sender and Receiver units
are set to channel 0.
1. Access the Web interface by entering the IP address of the desired Sender or
Receiver unit in the address bar of a Web browser. Refer to Displaying the IP Address
(page 20) if necessary.
2. Log in as Administrator or User.
3. Click the Network tab. The current channel is displayed within the Network Mode
window group.
4. Click the Channel Selection drop-down list and select the desired channel.
Channel numbers can range from 0 to 255.
5. Click the Save button on the right-hand side of Network Mode window group.
Web Interface
Information
When connecting Sender and Receiver units, it is highly recommend that the
video channel for each unit is set to a channel other than 0. This will allow
for the addition of future Sender and/or Receiver units without causing video
channel conicts.
page | 20
Basic Operation Basic Operation