User manual

6. The following message will be displayed, at the top of the page, indicating that the
casting mode has been applied to the Sender or Receiver unit.
7. Repeat steps 1 - 5 for each Sender and Receiver to be changed.
For example, in Figure 2.1, let’s say we are currently connected to the Web interface
of Receiver unit R1. The numbers in blue represent the video channel that has been
assigned to each Sender and Receiver unit. Receiver unit R1 is set to video channel 4.
Sender unit S2 is also set to video channel 4. Therefore, we are only able to view the
source that is connected to Sender unit S2.
If we wanted to view the source that is connected to Sender unit S3, then we would
change Receiver unit R1 from channel 4 to channel 3.
Figure 2.1 - Switching between Sender units (sources).
Web Interface
page | 21
LAN
Receiver unit
Receiver unit
HDMI Out
HDMI Out
Sender unit
Sender unit
Sender unit
HDMI In
HDMI In
HDMI In
R
1
S
2
S
1
R
2
S
3
2
4
1
4
3
Basic Operation