User manual

page | 23
Web Interface
1. Access the Web interface by entering the IP address of the Sender unit in the
address bar of a Web browser. Refer to Displaying the IP Address (page 23),
if necessary.
2. Log in as Administrator.
3. Click the Network tab. The current IP Mode will be highlighted within the IP Setup
window group. In the illustration below, the (default) Auto IP button is highlighted.
4. Click the desired IP Mode button. The selected IP Mode button will turn blue.
If DHCP is selected, a DHCP server will automatically assign an IP address to each
Sender and Receiver unit.
If Static is selected, the IP Address, Subnet Mask, and Default Gateway elds must
entered manually. Refer to Setting the IP Address (page 24).
5. Click the Save button on the right-hand side of IP Setup window group.
6. Click the Reboot button near the bottom of the page.
7. Repeat steps 2 - 5 for each Sender and Receiver to be changed.
Basic Operation