User manual
page | 24
Web Interface
Setting the IP Address
The HD over IP w/ RS-232 and 2-way IR can be set to Auto IP, DHCP, or Static IP mode.
By default, the Sender and Receiver units are shipped in Auto IP mode. In order to use a
specic IP address, the desired Sender and/or Receiver units must be placed in Static IP
mode. See Setting the IP Mode (page 22). Contact the system administrator to obtain
available IP addresses.
1. Access the Web interface by entering the IP address of the Sender unit in the
address bar of a Web browser. Refer to Displaying the IP Address (page 24),
if necessary.
2. Log in as Administrator.
3. Click the Network tab. The current IP Mode will be highlighted within the IP Setup
window group.
4. Click the Static button.
5. Enter the IP address, subnet mask, and default gateway for this unit.
6. Click the Save button on the right-hand side of IP Setup window group.
7. Repeat steps 1 - 6 for each Sender and Receiver to be changed.
Basic Operation
Basic Operation