User manual

page | 25
Web Interface
Enabling or Disabling Video over IP
This feature is useful for masking video. Disabling the video on the Sender unit will mask
the video on all connected Receiver units (multicast mode only). To mask the video on
selected Receiver units, disable the video on the desired Receiver units. By default, the
Video over IP option is enabled.
1. Access the Web interface by entering the IP address of the Sender or Receiver unit
in a Web browser. Refer to Displaying the IP Address (page 25), if necessary.
2. Log in as Administrator.
3. Click the Functions tab.
4. By default, the Video over IP option is enabled. Click the Enable Video over IP
check box to remove the check mark and mask the video. Click the check box
again to add the check mark and enable the video.
5. Click the Save button within the Video over IP group.
6. Click the Reboot button at the bottom of the page.
7. Repeat steps 1 through 5 for each Sender and/or Receiver unit in the system.
Basic Operation