User manual

page | 26
Web Interface
Enabling or Disabling HDCP
As a rule, an HDCP-compliant display must be used when displaying HDCP content from
a source device (e.g. Blu-ray). However, there may be instances where we simply want to
view the desktop of a computer. Normally, this isn’t a problem. Yet, some computers will
always transmit HDCP even though HDCP is not required. Disabling this feature will force
the computer to not transmit HDCP.
1. Access the Web interface by entering the IP address of the Sender unit in a Web
browser. Refer to Displaying the IP Address (page 26), if necessary.
2. Log in as Administrator.
3. Click the Functions tab.
4. By default, the HDCP content is passed through. To disable HDCP content from being
passed, click the HDCP Enable check box to remove the check mark. Click the check
box again to add the check mark and allow HDCP content to be passed.
5. Click the Save button within the Video over IP group.
6. Click the Reboot button at the bottom of the page.
7. Repeat steps 1 through 5 for each Sender and/or Receiver unit in the system.
Basic Operation Basic Operation