User manual

page | 29
EDID Management
Using the Downstream EDID
By default, the (downstream) EDID from the display, connected to the Receiver unit,
is used. If the internal EDID is being used (see previous page), then use the following
procedure to use the downstream EDID.
1. Access the Web interface for the Receiver unit.
2. Login as Administrator.
3. Click the Functions tab.
4. Make sure that the Copy EDID of Connected Display box is checked. This is the
default setting. Click this box if it is not checked then click the Save button.
5. Click the Save button within the Video over IP group.
6. The following message will be displayed, at the top of the page:
7. After a few moments, the following message will be displayed:
8. Click the Reboot button at the bottom of the page.
9. The Sender unit will now use the EDID of the downstream sink device.
Warning!
Clicking the Load Internal EDID button, under the Sender unit, will override
the status of the Copy EDID of Connected Display check box.
Basic Operation