User manual
page | 31
4. Click the Unicast button under the Network Mode window group. When selected,
the Unicast button will be highlighted in blue.
5. Click the Save button in the lower-right corner of the Network Mode window group.
6. The following message will be displayed, at the top of the page, indicating that the
casting mode has been applied to the Sender or Receiver unit.
7. After a few seconds, the following message will appear at the top of the screen:
8. Click the Reboot button near the bottom portion of the page to apply the changes.
9. Repeat steps 1 - 7 to congure each Sender and Receiver unit to unicast mode.
Unicast and Multicast Modes
Important!
When switching between unicast and multicast modes, both Sender and
Receiver units need to be congured identically.
Basic Operation