User manual

page | 32
Unicast and Multicast Modes
Switching between Sender units in Unicast mode
When multiple Sender and Receiver unit are used in unicast mode, the HD over IP
w/ RS-232 and 2-way IR behaves as a switcher. In unicast mode, a Sender unit can
communicate with only one Receiver unit at a time.
In the example below, we will switch Receiver unit R1 to receive the source on Sender
unit S1.
Figure 2.5 - Unicast mode: Sender S2 transmitting to Receiver unit R1.
1. Access the Web interface for Receiver unit R1.
2. Login as Administrator or User.
3. Click the Network tab and change the video channel. Refer to Setting the Video
Channel if necessary.
4. Click the Save button.
5. The following message will be displayed, at the top of the page, indicating that the
casting mode has been applied to the Sender or Receiver unit.
6. Receiver unit R1 is now receiving the source on Sender unit S1, as shown on the
next page.
LAN
Receiver unit
Receiver unit
HDMI Out
HDMI Out
Sender unit
Sender unit
Sender unit
HDMI In
HDMI In
HDMI In
R
1
S
1
S
2
R
2
S
3
2
1
5
1
2
Basic Operation Basic Operation