User manual

page | 34
Unicast and Multicast Modes
In order to solve the problem, in Figure 2.7, we would need to make sure that each of
the Sender units is set to a unique channel number.
When using unicast mode, each of the Sender units must be assigned a unique
channel and should never be changed. Use the Receiver unit to switch (channels)
between Sender units.
The HD over IP w/ RS-232 and 2-way IR can be used with just over 65,000 Sender
and Receiver units, depending upon the network bandwidth and the number of ports
on your network switch.
Information
In unicast mode, if an additional Sender unit is introduced into a system with
the same channel as another Sender unit, then the Receiver unit will continue
to receive A/V data from the Sender unit which was connected rst.
Basic Operation Basic Operation