User manual
page | 36
4. Click the Multicast button under the Network Mode group. When selected,
the Multicast button will be highlighted in blue.
5. Click the Save button in the lower-right corner of the Network Mode group.
The following message will be displayed, at the top of the page, indicating that the
casting mode has been applied to the Sender or Receiver unit.
6. Click the Reboot button near the bottom portion of the page to apply the changes.
7. Repeat the steps above in order to congure the Sender unit to multicast mode.
Unicast and Multicast Modes
Important!
When switching between unicast and multicast modes, both Sender and
Receiver units need to be congured identically.
Basic Operation
Basic Operation