User manual

page | 38
1. Access the Web interface for both the Sender and Receiver unit.
2. Login as Administrator.
3. Click the Functions tab.
4. Locate the Serial over IP group and change the RS-232 settings to match the
settings of the RS-232 device that is being used. In this case, we need to use the
settings from Table 2.1:
5. Make sure that the Enable Serial over IP box is checked.
6. Click the Save button in the lower-right corner of the Serial over IP group.
7. The following message will be displayed, at the top of the page, indicating that the
new Serial over IP options have been applied.
8. Click the Reboot button near the bottom portion of the page to apply the changes.
If the unit is not rebooted within a certain period of time, the following message will be
displayed:
9. Repeat steps 1 - 7 for the Receiver unit.
Using RS-232
Basic Operation Basic Operation