User manual

IR EXTENDER INSTALLATION
How to Connect the IR Extender
1 Plug the IR extender into the Remote port on the front of the Switcher Unit
2 Flip the Dip Switch #1 underneath the unit from the set that is not outlined on the
previous page to the ON position
7
IR CODES
In the event of IR confl icts, please do the following:
1. Remove the battery cover from the back of the RMT4-IR remote.
2. Locate the Dip Switches above the batteries.
3. Switch the Dip Switches on the RMT4-IR to any of the combinations pictured
below.
4. Dip Switches 1 and 2 in the RMT4-IR correspond with Dip Switches 3 and 4 on
the bottom of the 4x1 DVI Switch respectively. Switch the switches on the bottom of
the 4x1 DVI Switch to match the dip switches on the RMT4-IR. The 4x1 DVI Switch-
er is now set to a new IR Code.
1
2
Remote Channel 0:
1
2
Remote Channel 1:
1
2
Remote Channel 2:
1
2
Remote Channel 3: