User manual

2
READ THESE NOTES BEFORE INSTALLING OR
OPERATING THE 1:2 SPLITTER FOR HDMI 1.3 WITH DIGITAL AUDIO
• By default, display information from the display connected to HDMI output port
1 is sent back to the source. Therefore, the other display connected to the 1:2
Splitter for HDMI 1.3 with Digital Audio must be capable of accepting the timings,
resolutions and audio formats of the display that is connected to HDMI output
port 1. It is recommended that the display with the lowest native resolution
be connected to HDMI output port 1. This is to ensure that a compatible video
signal will be able to be displayed on all connected monitors. There is a generic
EDID programmed into the 1:2 Splitter for HDMI 1.3 with Digital Audio that can
be used instead. Please see page 7 for more details.
• The digital TOSLINK output only supports the transmission of the following
audio formats:
- LPCM 2-channel (32 ~ 192 Khz sampling rate)
- Dolby AC3 2-channel and 5.1-channel
- Dolby Digital Plus 5.1-channel
- DTS 2-channel and 5.1-channel
• LPCM of more than 2 channels, Dolby Digital Plus of 7.1 channels, DTS-HD
and Dolby TrueHD are supported through the HDMI output only (not on the
TOSLink output).
*When used with a HDMI to DVI adapter
OPERATION NOTES