User`s manual

RMT-8HDS REMOTE CONTROL INSTALLATION
9
1. Remove battery cover from the back of the RMT-8HDS-IR remote.
2. Verify that dip switches 1 & 2 are in the down (OFF) position.
3. Insert the battery, hold the battery so that you can see the positive side facing up.
The side that is not marked must be facing down.
4. Test the RMT-8HDS-IR remote by pressing ONLY one button at a time. The
indicator light on the remote will fl ash once each time you press a button. WARNING:
Do not press multiple buttons simultaneously and do NOT press buttons rapidly. These
actions will cause the remote to reset and steps 1-4 will have to be repeated.
Note: The RMT-8HDS-IR ships with two batteries. One battery is required for operation,
the second battery is complimentary.
The following are the dip switch combinations that correspond to the Remote Code
menu option on the HDMI to HDSDI Scaler (Please see Menu Functions section for
more information):
1
2
Remote Channel 0:
1
2
Remote Channel 1:
1
2
Remote Channel 2:
1
2
Remote Channel 3:
RS-232 INTERFACE / FIRMWARE UPDATE PROCEDURE
The HDMI1.3 to 3GSDI Scaler can be controlled via IR remote, the RS-232 serial port,
and the USB port. For USB control, drivers must be installed fi rst. The USB port is
seen as a virtual COM port inside Windows
tm
. Firmware updates may be performed
through the USB port only (not the RS-232 port). Please visit the download section on
our website for fi rmware updates and information on how to control this unit using RS-
232 protocols. This web address (URL) has links to the necessary documents and fi les:
http://www.gefen.com/kvm/support/download.jsp