® HDMI® Super Booster Cable EXT-HDMISB User Manual www.gefen.
ASKING FOR ASSISTANCE Technical Support: Telephone Fax (818) 772-9100 (800) 545-6900 (818) 772-9120 Technical Support Hours: 8:00 AM to 5:00 PM Monday thru Friday PST Write To: Gefen, LLC c/o Customer Service 20600 Nordhoff St Chatsworth, CA 91311 www.gefen.com support@gefen.com Notice Gefen, LLC reserves the right to make changes in the hardware, packaging and any accompanying documentation without prior written notice.
CONTENTS 1 Introduction 2 Operation Notes 3 Features 4 Panel Layout 5 Connecting The HDMI Super Booster Cable 6 Using Video Equalization To Get An Optimal Picture 7 Specifications 8 Warranty
INTRODUCTION Congratulations on your purchase of the HDMI Super Booster Cable. Your complete satisfaction is very important to us. Gefen Gefen delivers innovative, progressive AV, computer and electronics addon solutions that harness integration, extension, distribution and conversion technologies.
OPERATION NOTES READ THESE NOTES BEFORE INSTALLING OR OPERATING THE HDMI SUPER BOOSTER CABLE • A 5V DC power supply is included. In normal scenarios, the source powers the cable by providing a 5V signal within the cable. If the necessary voltage is not present, the included 5V DC power supply may be used to provide power. Please see page 5 for more information. • The HDMI Super Booster Cable must be connect as instructed on page 5. The metal booster head should be located on the display side.
FEATURES Features • Perfect digital high definition video sent over long stretches of HDMI cables • Locate an HDMI display up to 200 feet away from any HDTV source • Supports resolutions up to 1080p, 2K, and 1920 x 1200 • HDMI/HDCP compliant HDMI 1.
PANEL LAYOUT Female Side Mono-Lok™ Secure Cable Locking Nut Power LED Indicator HDMI Output Male Side Mono-Lok™ Secure Cable Locking Screw HDMI Male Connector 4 Equalization Trim Pot
CONNECTING THE HDMI SUPER BOOSTER CABLE How to Connect the HDMI Super Booster Cable 1. Connect the HDMI Super Booster Cable’s male end to the HDMI source. The male end has no lights or adjustment controls on it and is considerably smaller than the larger female end. 2. Connect the HD display to the large female end of the HDMI Super Booster Cable using a short user-supplied HDMI cable. The female end of the HDMI Super Booster has the LED Power Indicator and the EQ Trim Pot control plainly visible. 3.
USING VIDEO EQUALIZATION TO GET AN OPTIMAL PICTURE Video Equalization using the internal DIP switches There is a small bank of switches underneath the booster chassis known as DIP switches. To use them to adjust the video behavior, use a small pointed object to push the switches ON or OFF as follows: DIP Switch 2 is not used. DIP Switch 1 turns on automatic video equalization (tuning out of unwanted noise) when in the OFF position.
SPECIFICATIONS Video Amplifier Bandwidth ....................................................................... 165 MHz Input Video Signal .............................................................................. 1.2 Volts p-p Single Link Range ................................................................... 1080p/1920 x 1200 HDMI™ Connector .............................................................. Type A 19 Pin Female Female Connector Dimensions ................................. 1.563”W x 1.
8
Rev A2 20600 Nordhoff St., Chatsworth CA 91311 1-800-545-6900 818-772-9100 www.gefen.com Pb fax: 818-772-9120 support@gefen.