Owners manual

page | 19
Basic Operation
Using Multiple Sender Units
14. The Power Indicator LED indicator on the Receiver unit will slowly ash bright
magenta, indicating that it is in register mode.
15. If a new Sender unit has been found, the registration process will begin:
To cancel the searching process, press the Sender button on the IR remote
control. You will be returned to the Select Transmitter screen:
If no additional Sender units are found, then the following message will be
displayed.
16. After a few moments, the Select Transmitter window (see above) will be displayed.
®
Power Indicator
Info
Link
Wireless for HDMI 5 GHz R
HDMI
IR IN
Flashes magenta
Adding 1080PSRS
Select Transmitter
1080PSRS
Setup
New WHDI source was not found