User manual

7
Front Panel Controls
The GefenPRO 10x4 DVI Dual Link Matrix uses an LED display that shows
the current routing status and is used to control the Matrix. When the unit is
powered, four (4) LEDs will indicate the current routing status:
In the example above, all DVI sources have been routed to Output 1.
The top row of ten (10) buttons correspond to each input on the Matrix. The four
buttons on the left correspond to each of the outputs on the Matrix (see pages 4
and 5).
The GefenPRO 10x4 DVI Dual Link Matrix can route a source to one monitor at
a time or a source to multiple monitors at once. Routing a source to a monitor is
a two-step process: The fi rst step is to select the monitor (1-4) to which the source
will be routed. The second step is to select the source (1-10).
Routing a Source to a Monitor
Example 1:
Route the source device connected to In 2 to the monitor connected to Out 1.
1. Press the Output 1 button. The Ouput 1 button will glow blue, indicating that
it has been pressed.
CONNECTING AND OPERATING
THE 10X4 DVI DUAL LINK MATRIX