User manual

32
IP CONTROL - MANAGE EDID
SET INPUT TO DEFAULT EDID
Pressing the SET INPUT TO DEFAULT EDID button will display additional
options. The following page will open.
On this page, local memory locations can be selected to receive the built-in EDID
stored in the 10x4 DVI Dual Link Matrix. To set an input’s local memory location
to the default EDID follow the steps below.
1. Select any number of inputs by clicking on the desired checkboxes.
2. Click on the Set Default EDID button to update the change(s).
Note: After this command is complete the Web Interface will return to the VIEW
MATRIX STATUS page.
This page will automatically refresh every minute. However, the REFRESH
button can be pressed at any time to return the current status of the Matrix.