User manual

5
INTRODUCTION
Back
9 GroundingTerminal
Providesadischargepathtogroundincaseashortcircuitoccursbetweenthe“hot”
leadofthepowersupplyandtheenclosureoftheMatrix.Thegroundingwireshouldbe
attachedfromthegroundingterminaltoanapprovedgroundpath.
10 IPControl
ConnectanEthernetcabletothisporttocontrolthe4x4 Matrix for HDMI w/4 ELR-POL
OutputsusingIPControl.Seepage35formoreinformationonconguringthematrixfor
IPcontrol.
11 IROut(All)
ConnectanIRextendercabletothisjack(Gefenpartno.EXT-RMT-EXTIR).
12 IRIn(All)
ConnectanIRExtender(Gefenpartno.EXT-RMT-EXTIR)cabletothisjack.
13 RS-232
ConnectanRS-232cablefromthisDB-9connectortotheRS-232controldevice.See
page34formoreinformation.
14 USB
Serviceportformanufactureruseonly.
15 IRIn(A-D)
Connecta3.5mm-to-3.5mmmini-monocablebetweeneachoftheseIRjacksand
theGefenPACSorGefenMiniPACS.IREmittersorIRExtenderswillnotfunctionif
connectedtothisjack.
16 IROut(A-D)
ConnectanIREmitter(Gefenpartno.EXT-2IREMIT)cablefromeachofthesejacksand
eachsourcedevice.
17 ELR-POLOutputs(A-D)
ConnectaCAT-5e(orbetter)cablefromeachofthesejackstotheELR-POLInjackson
theELR-POLReceiverunits.
18 HDMIInputs(1-4)
ConnectaHi-DefsourcetoeachoftheseportsusingHDMIcables.
19 PowerSwitch
TurnthepowerONorOFFusingthisswitch.
20 100/240ACPowerReceptacle
ConnecttheincludedACpowercordtothisreceptacleandconnecttheplugtoan
availableelectricaloutlet.