User manual

44
RS-232 / IP CONTROL
#sgateway Command
The#sgatewaysetsthegateway(router)address.Dot-decimalnotationmustbeused
whenspecifyingthegatewayaddress.Thedefaultgatewayaddressis192.168.1.254.
Syntax:
#sgateway param1


Parameters:
param1 Gatewayaddress

Notes:
Thematrixmustberebootedafterexecutingthiscommand.
Example:
#sgateway 192.168.2.1
GateWay Address 192.168.2.1 Is Set. Please Reboot The Unit.
#show_gateway Command
The#show_gatewaycommandshowsthecurrentgatewayaddress.

Syntax:
#show_gateway


Parameters:
None
Example:
#show_gateway
GATEWAY ADDRESS IS: 192.168.2.1