User manual

9
IR REMOTE CONTROL UNIT CONFIGURATION
Setting the IR Remote Control Channel
In the event that IR commands from other remote controls interfere with the
supplied IR Remote Control unit, changing the IR channel on the IR Remote
Control unit will fi x the problem. The IR Remote Control unit has a bank of DIP
switches used for setting the IR channel.
The DIP switch bank is located underneath the battery cover.
1 2
1 2
1 2
1 2
Channel 2:
Channel 0:
Default
Channel 1:
Channel 3:
Exposed DIP switch bank between the
battery slots.
It is important that the IR channel on the Remote Control unit, matches the IR
channel set on the GefenToolBox High Defi nition 1080p Scaler. For example, if
both DIP switches on the IR Remote Control unit are set to IR channel 0 (both
DIP switches down), then the High Defi nition 1080p Scaler must also be set to IR
channel 0. Refer to page 15 on changing the IR channel on the High Defi nition
1080p Scaler.