User manual

10
How to Setup the Wireless VGA SR Sender Unit
1. Connect source devices to the Wireless VGA SR sender unit. The sender
unit has the following connection options:
VGA
Component
S-Video
Composite
2. Connect a single analog audio source to the Wireless VGA SR sender unit
using a 3.5mm mini-jack audio cable.
3. Connect one or both of the following output device types to the Wireless
VGA SR receiver unit:
VGA (VGA cable included)
Component
4. Connect a single analog audio output device to the 3.5mm mini-jack output
on the Wireless VGA SR receiver unit.
5. Connect the included 12V DC power supplies to both the Wireless VGA SR
sender and receiver units.
6. Toggle the power switch on both the Wireless VGA SR sender and receiver
units.
7. Turn on all output and source devices.
How to Operate the Wireless VGA SR
Once all units, sources, and output devices are powered and turned on, the
sending and receiving units will begin their boot-up sequence.
During this sequence all channel LEDs (blue) on the sender and receiver units
will turn on and remain on. The output will display a blue screen with the text:
“Wi-Fi initial...”
Once the initial boot-up sequence is complete, the currently selected input (on
the sender) and output (on the receiver) will be active (blue). The LED for the
channel in operation will also be on (blue). The output will display a blue screen
with the text:
“Search channel XX” (where XX is the current channel)
During the fi nal stages of the boot-up sequence, the Wi-Fi LED should turn on
(green) while the sender and receiver units attempt to establish contact with each
other.
Once a link has been established, the Wi-Fi LED will begin to blink rapidly. This
will indicate that data is being transmitted from the sender to the receiver unit.
Video should now be output through the Wireless VGA SR receiver unit.
CONNECTING AND OPERATING THE WIRELESS VGA SR