User manual

CONNECTING AND OPERATING THE WIRELESS VGA SR

If the Wi-Fi LED remains on (green) and does not blink, the sender and receiver

units are not linked and video/audio is not being transmitted. When this occurs,

video will not be displayed and the output will remain on a blue screen. This text

will be displayed:

“No Wi-Fi connection”

Try moving the sender or receiver unit’s location until a link is established and the

Wi-Fi LED is blinking green.

The Wi-Fi LED may occasionally blink red. This indicates low signal strength.

While the link between the sender and receiver units will most likely remain

intact, video/audio drop-outs may occur. Try moving the sender or receiver unit’s

location until a link is established and the Wi-Fi LED is blinking green.

If the Wi-Fi LED remains red, the signal strength is too low and no video will be

output. Try moving the sender or receiver unit’s location until a link is established

and the Wi-Fi LED is blinking green.

How to Switch Input Sources on the Wireless VGA SR

Use the switch button on the front panel of the Wireless VGA SR sender unit,

labeled “S”, to cycle between the available input sources. The currently selected

source will be indicated by a blue LED. Each press will progress to the next input

in the following order:

VGA Component S-Video Composite

How to Switch Outputs on the Wireless VGA SR

Use the switch button on the front panel of the Wireless VGA SR receiver unit,

labeled “S”, to cycle between the available outputs. The currently selected source

will be indicated by a blue LED. Each press will progress to the next output in the

following order:

How to Switch Channels on the Wireless VGA SR

If there is signiﬁ cant interference on a particular channel, or the currently selected

channel is unstable, changing the channel may alleviate the issue. To change the

channel, press the channel button, labeled “C” on either the sender or receiver

unit. Changes on one unit will automatically be reﬂ ected on the other unit. If there

is currently no link between the sender and receiver, the channel button will not

be operational.

VGA Component