SDS
1 Advice on Safe Handling
1.1.
Use the proper personal protective equipment during handling. Minimize dust
generation and accumulation. Use good housekeeping practices.
2 Protective measures
2.1.
Use methods to minimize generation of dust. Wash thoroughly after
handling. PVC resin and compound processing under extreme temperatures
beyond normal processing temperatures may result in the release of
hydrogen chloride (HCl). Use only in well-ventilated areas.
3 Storage
3.1.
Store in a dry place away from direct sunlight, heat, and incompatible materials.
Store away from food and beverages. Reseal containers immediately after
use. Store in a well-ventilated, cool area free from high humidity.
All personal protective equipment should be selected in accordance with the hazard
assessment required by 29 CFR 1910.132(d).
1 Respiratory Protection
1.1.
For most conditions, no respiratory protection should be needed. However, if dust
is
produced during handling, a NIOSH approved air purifying filter respirator that
meets the
requirements of 29 CFR 1910.134 should be used.
1.2.
Full-face self contained breathing apparatus may be needed when dealing with
vapors
from combustion of product. Respirators must be selected based on
the airborne levels
found in the workplace and must not exceed the working
limits of the respirator.
2 Eye Protection
2.1.
Use safety glasses. If there is a potential for exposure to particles, which
could cause
mechanical injury to the eye, wear chemical or dust proof
goggles.
3 Skin Protection
3.1.
Skin protection meeting the requirements of 29 CFR 1910.132 may be
needed. Under
normal conditions, work clothing should be sufficient. Wash
skin if contacted by PVC
powder or pellets. Wash contaminated clothing
before reusing. Gloves for thermal
protection may be necessary when
handling hot or molten compound.
4 Engineering Controls
4.1.
Provide general and/or local exhaust ventilation to control airborne levels below
the
exposure guidelines. Adequate ventilation should be provided as conditions
warrant.
Local exhaust ventilation should comply with OSHA regulations and
the American
Conference of Industrial Hygienists, Industrial Ventilation - A
Manual of Recommended
Practice.
8. Exposure Controls / Personal Protection
7. Handling and Storage