MSDS

Methods for cleaning up
Small Spills: Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to
remove residual contamination. This material and its container must be disposed of as hazardous
waste. Should not be released into the environment.
Large Spills: Use a non-combustible material like vermiculite, sand or earth to soak up the product
and place into a container for later disposal. Prevent product from entering drains. Do not allow
material to contaminate ground water system.
Other information
Clean up in accordance with all applicable regulations.
7. Handling and Storage
Handling
Wear personal protective equipment. Avoid breathing mists or aerosols of this product. Avoid
prolonged exposure. Use with adequate ventilation. Avoid contact with skin and eyes. Wash
thoroughly after handling. Pressurized container: Do not pierce or burn, even after use. Do not
spray on a naked flame or any other incandescent material. Do not smoke while using or until
sprayed surface is thoroughly dry. DO NOT handle, store or open near an open flame, sources of
heat or sources of ignition. Protect material from direct sunlight. Do not cut, weld, solder, drill,
grind, or expose containers to heat, flame, sparks, or other sources of ignition. All equipment used
when handling the product must be grounded. Ground and bond containers when transferring
material. Do not re-use empty containers. Do not use if spray button is missing or defective. Avoid
release to the environment.
Storage
Contents under pressure. The pressure in sealed containers can increase under the influence of
heat. Do not puncture, incinerate or crush. Keep away from heat, sparks and open flame. Keep
container tightly closed in a cool, well-ventilated place. Keep away from food, drink and animal
feedingstuffs. Keep out of the reach of children.
ACGIH
8. Exposure Controls / Personal Protection
Occupational exposure limits
Components Type Value Form
Crystalline silica (14808-60-7) 0.025 mg/m3 Respirable fraction.
TWA
Morpholine (110-91-8) 20 ppm
TWA
U.S. - OSHA
Components Type Value Form
Crystalline silica (14808-60-7) 2.4 mppcf Respirable.
TWA
0.1 mg/m3 Respirable.
0.1 mg/m3 Respirable dust.
0.3 mg/m3 Total dust.
Morpholine (110-91-8) 20 ppm
PEL
70 mg/m3
105 mg/m3
STEL
30 ppm
20 ppm
TWA
70 mg/m3
Canada - Alberta
Components Type Value Form
Crystalline silica (14808-60-7) 0.1 mg/m3 Respirable particles.
TWA
Morpholine (110-91-8) 20 ppm
TWA
71 mg/m3
Canada - British Columbia
Components Type Value Form
Crystalline silica (14808-60-7) 0.025 mg/m3 Respirable fraction.
TWA
Morpholine (110-91-8) 20 ppm
TWA
Canada - Ontario
Components Type Value Form
Crystalline silica (14808-60-7) 0.1 mg/m3 Respirable fraction.
TWA
Morpholine (110-91-8) 30 ppm
STEL
105 mg/m3
20 ppm
TWA
70 mg/m3
GEL GLOSS AEROSOL GA-12
3481 Version #: 00 Revision date: 01-29-2010 Print date: 01-29-2010
CPH MSDS NA
3 / 8