User's Manual

Cinterion

EHS8 Hardware Interface Overview Page 35 of 43

 EHS8_HIO_v02.770 2014-08-11

Confidential / Preliminary

5.4 Compliance with FCC and IC Rules and Regulations

The Equipment Authorization Certification for the Gemalto M2M reference application

described in

Section 5.3 will be registered under the following identifiers:

FCC Identifier: QIPEHS8 Industry Canada Certification Number: 7830A-EHS8

Granted to Gemalto M2M GmbH

Manufacturers of mobile or fixed devices incorporating EHS8 modules are authorized to use

the FCC Grants and Industry Canada Certificates of the EHS8 modules for their own final

products according to the conditions referenced in these documents. In this case, an FCC/ IC

label of the module shall be visible from the outside, or the host device shall bear a second

label stating "Contains FCC ID QIPEHS8", and accordingly “Contains IC 7830A-EHS8“. The

integration is limited to fixed or mobile categorised host devices, where a separation distance

between the antenna and any person of min. 20cm can be assured during normal operating

conditions. For mobile and fixed operation configurations the antenna gain, including cable

loss, must not exceed the limits 2.15 (850 MHz) and 2.15 dBi (1900 MHz).

IMPORTANT:

Manufacturers of portable applications incorporating EHS8 modules are required to have their

final product certified and apply for their own FCC Grant and Industry Canada Certificate

related to the specific portable mobile. This is mandatory to meet the SAR requirements for

portable mobiles (see

Section 5.2 for detail).

Changes or modifications not expressly approved by the party responsible for compliance

could void the user's authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules and with Industry Canada licence-exempt RSS

standard(s). These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no guarantee that interference

will not occur in a particular installation. If this equipment does cause harmful interference to

radio or television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

• Consult the dealer or an experienced radio/TV technician for help.

This Class B digital apparatus complies with Canadian ICES-003.

If Canadian approval is requested for devices incorporating EHS8 modules the above note will

have to be provided in the English and French language in the final user documentation.

Manufacturers/OEM Integrators must ensure that the final user documentation does not

contain any information on how to install or remove the module from the final product.

6 Document Information