User Manual
Table Of Contents
- Contents
- Tables
- Figures
- 1 Introduction
- 2 Interface Characteristics
- 2.1 Application Interface
- 2.2 RF Antenna Interface
- 2.3 Sample Application
- 3 Operating Characteristics
- 4 Mechanical Dimensions, Mounting and Packaging
- 5 Regulatory and Type Approval Information
- 6 Document Information
- 7 Appendix
Cinterion
®
ELS31-V/ELS51-V Hardware Interface Overview
5.4 Compliance with FCC and IC Rules and Regulations
27
ELS31-V_ELS51-V_HIO_v00.502 2015-12-07
Confidential / Preliminary
Page 26 of 35
5.4 Compliance with FCC and IC Rules and Regulations
The Equipment Authorization Certification for the Gemalto M2M reference application de-
scribed in Section 5.3 will be registered under the following identifiers:
• ELS31-V:
FCC Identifier: QIPELS31-V (not yet granted)
Industry Canada Certification Number: 7830A-ELS31V (not yet granted)
Granted to Gemalto M2M GmbH
• ELS51-V:
FCC Identifier: QIPELS51-V (not yet granted)
Industry Canada Certification Number: 7830A-ELS51V (not yet granted)
Granted to Gemalto M2M GmbH
Manufacturers of mobile or fixed devices incorporating ELS31-V / ELS51-V modules are au-
thorized to use the FCC Grants and Industry Canada Certificates of the ELS31-V / ELS51-V
modules for their own final products according to the conditions referenced in these docu-
ments. In this case, an FCC/ IC label of the module shall be visible from the outside, or the host
device shall bear a second label stating "Contains FCC ID: QIPELS31-V" / "Contains FCC ID:
QIPELS51-V", and accordingly “Contains IC: 7830A-ELS31V“ / “Contains IC: 7830A-ELS51V“.
The integration is limited to fixed or mobile categorised host devices, where a separation dis-
tance between the antenna and any person of min. 20cm can be assured during normal oper-
ating conditions.
For mobile and fixed operation configurations the antenna gain, including cable loss, must not
exceed the limits in the following Table 12 for FCC and IC.
IMPORTANT:
Manufacturers of portable applications incorporating ELS31V / ELS51-V modules are required
to have their final product certified and apply for their own FCC Grant and Industry Canada Cer-
tificate related to the specific portable mobile. This is mandatory to meet the SAR requirements
for portable mobiles (see Section 5.2 for detail).
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules and with Industry Canada licence-exempt RSS
standard(s). These limits are designed to provide reasonable protection against harmful inter-
ference in a residential installation. This equipment generates, uses and can radiate radio fre-
quency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference
Table 12: Antenna gain limits for FCC and IC
Operating band FCC limit IC limit Unit
Maximum gain in lower operating bands with f< 1GHz
(LTE Bd13)
10.4 7.4
dBi
Maximum gain in higher operating bands with f=1700MHz
(LTE Bd4)
6.5 6.5 dBi