User's Manual
Table Of Contents
- Contents
- Tables
- Figures
- 1 Introduction
- 2 Interface Characteristics
- 2.1 Application Interface
- 2.2 RF Antenna Interface
- 2.3 Sample Application
- 3 Operating Characteristics
- 3.1 Operating Modes
- 3.2 Power Up/Power Down Scenarios
- 3.3 Power Saving
- 3.4 Power Supply
- 3.5 Operating Temperatures
- 3.6 Electrostatic Discharge
- 3.7 Blocking against RF on Interface Lines
- 3.8 Reliability Characteristics
- 4 Mechanical Dimensions, Mounting and Packaging
- 5 Regulatory and Type Approval Information
- 6 Document Information
- 7 Appendix
Cinterion
®
ELS61-AUS Hardware Interface Description
4.3 Packaging
88
ELS61-AUS_HID_v00.031 2016-06-03
Confidential / Preliminary
Page 88 of 102
4.3.3 Trays
If small module quantities are required, e.g., for test and evaluation purposes, ELS61-AUS may
be distributed in trays (for dimensions see Figure 53). The small quantity trays are an alterna-
tive to the single-feed tape carriers normally used. However, the trays are not designed for ma-
chine processing. They contain modules to be (hand) soldered onto an external application (for
information on hand soldering see [4]).
Trays are packed and shipped in the same way as tape carriers, including a moisture barrier
bag with desiccant and humidity indicator card as well as a transportation box (see also Section
4.3.2).
Figure 53: Tray dimensions