User's Manual
Table Of Contents
- Contents
- Tables
- Figures
- 1 Introduction
- 2 Interface Characteristics
- 2.1 Application Interface
- 2.2 RF Antenna Interface
- 2.3 Sample Application
- 3 Operating Characteristics
- 3.1 Operating Modes
- 3.2 Power Up/Power Down Scenarios
- 3.3 Power Saving
- 3.4 Power Supply
- 3.5 Operating Temperatures
- 3.6 Electrostatic Discharge
- 3.7 Blocking against RF on Interface Lines
- 3.8 Reliability Characteristics
- 4 Mechanical Dimensions, Mounting and Packaging
- 5 Regulatory and Type Approval Information
- 6 Document Information
- 7 Appendix
Cinterion
®
ELS61-AUS Hardware Interface Description
5.4 Compliance with FCC Rules and Regulations
94
ELS61-AUS_HID_v00.031 2016-06-03
Confidential / Preliminary
Page 94 of 102
5.4 Compliance with FCC Rules and Regulations
The Equipment Authorization Certification for the Gemalto M2M reference application de-
scribed in Section 5.3 will be registered under the following identifiers:
FCC Identifier: QIPELS61-AUS
Granted to Gemalto M2M GmbH
Manufacturers of mobile or fixed devices incorporating ELS61-AUS modules are authorized to
use the FCC Grants of the ELS61-AUS modules for their own final products according to the
conditions referenced in these documents. In this case, an FCC label of the module shall be
visible from the outside, or the host device shall bear a second label stating "Contains FCC ID:
QIPELS61-AUS”. The integration is limited to fixed or mobile categorized host devices, where a
separation distance between the antenna and any person of min. 20cm can be assured during
normal operating conditions. For mobile and fixed operation configurations the antenna gain,
including cable loss, must not exceed the limit 2.15 dBi for 700MHz, 850MHz, 900MHz,
1800MHz and 2100MHz.
IMPORTANT:
Manufacturers of portable applications incorporating ELS61-AUS modules are required to have
their final product certified and apply for their own FCC Grant related to the specific portable
mobile. This is mandatory to meet the SAR requirements for portable mobiles (see Section 5.2
for detail).
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.