User's Guide

English 13
CAUTION
• Do not use bleach, chlorine, alcohol, or aromatic-based solutions, moisturizing or antibacterial
soaps or scented oils to clean the device, the humidifier tub or air tubing. These solutions may
cause damage or affect the humidifier performance and reduce the life of the products. Exposure
to smoke, including cigarette, cigar or pipe smoke, as well as ozone or other gases, may damage
the device. Damage caused by any of the foregoing, will not be covered by ResMed's limited
warranty.
• Leave the humidifier tub to cool for ten minutes before handling to allow the water to cool and to
make sure that the humidifier tub is not too hot to touch.
The following sections will help you with:
• Disassembling
• Cleaning
• Checking
• Reassembling.
Disassembling
1. Hold the humidifier tub at the top and bottom, press it gently and pull it away from the device.
Note: Take care when handling the humidifier tub as the humidifier tub may be hot. Allow 10 minutes
for the heater plate and any excess water to cool.
2. Open the humidifier tub and discard any remaining water.
3. Pinch the cuff of the air tubing, and gently pull it away from the device.
4. Hold both the cuff of the air tubing and the swivel of the mask, then gently pull apart.
5. Locate the outlet connector on the inside of the device and release it by pressing the clip firmly.
6. Remove the outlet connector by pulling it out through the outlet connector socket at the rear of the
device.
Cleaning
The following instructions are for home cleaning. Instructions for reprocessing devices intended for multi-
patient re-use can be found in the clinical guide.
You should clean the device, humidifier tub, air tubing, and outlet connector as described.