Installation Guide

FCC Rules and Industry Canada (IC) regulatory information
Compliance Statement (Part 15.19)
The equipment device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) This device must accept any interference received including interference that
may cause undesired operation.
Warning (Part 15.21)
Changes or modifications not expressly approved by CAlampcould void the user’s authority to operate the equipment.
Manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment.
Compliance Statement (Part 15.105(b))
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct
the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:
(1) this device
may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired
operation of the
device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation
est autorisée aux
deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout
brouillage
radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
Class B digital device notice
https://puls.calamp.com/wiki/HMU-3640_Hardware_%26_Installation_Guide 25/27
“CAN ICES-3 (B)/NMB-3(B)”
RF Radiation Exposure Statement
“The device has demonstrated compliance with the RF Exposure requirements of FCC Part 2.1093 and RSS102 Issue 5”
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to
operate this equipment.
FOR SOFTWARE, APPLICATION PROGRAMING INTERFACES (APIs) & DOCUMENTATION IMPORTANT: DO NOT
INSTALL OR USE THE
SOFTWARE OR DOCUMENTATION UNTIL YOU HAVE READ AND AGREED TO THIS LICENSE AGREEMENT. This
is a legal agreement
between you, the Customer, and CalAmp Wireless Networks Incorporated (“CalAmp”). By installing and/or using the software
or documentation, you are consenting to the terms of this License. If you do not agree to the terms of this non-exclusive License
Agreement, DO NOT INSTALL OR USE THE SOFTWARE, APIs OR DOCUMENTATION. For a full refund, return the
unused media package and all accompanying materials within seven (7) days to CalAmp. Where there is no packaging or media,
use of the software and/or documentation constitutes acceptance. Definitions: As used in this License Agreement, “Software”
means CalAmp’s LM Direct ™, LMU Manager™, LapTop Locator™, LMU Application/Programmable Event Generator™,
CDMA LMU Provisioning Tool, GPRS LMU Provisioning Tool, LMU Status, Clone Config, Hex
Dump, LM Exchange™ Traffic Monitor, Freewave Base Station Config, Remote Serial Port, App Watcher Service and/or other
software products licensed by CalAmp for use in computer applications development or integration including the computer
programs, libraries and related materials either contained on the media provided to you by or from CalAmp, or which you have
received or downloaded electronically. “Application” means a compiled or executable software program created by Developer
that uses some or all of the functionality of the Software. “Software Copies” means the actual copies of all or any portion of the
Software including backups, updates, merged or partial copies permitted hereunder or subsequently licensed to you.
“Documentation” means the non-Software information contained on the media provided with this package or downloaded and
which is used with and describes the operation and use of the Software. “Documentation Copies” means the actual copies of all or