DCAM-002 English user manual
1. TF Card Slot 2. Reset Button 3. Mic 4. Power Button 5. Mic Indicator (red) 6. Mic Button 7. Camera/Playback Button 8. Rack Pad (close) Right 9. LCD Display 10. Rec Indicator (red) 11. Rec Button 12. Switch Button 13. Rack Pad (open) Left 14. Sensor-Aligning Steering 15. AV In Interface(Optional) 16. AV Out Interface 17. USB Interface 18. 3M Adhesive Tape 19. Rack Pad 20. Screw Hole 21. CMOS Sensor 22. Night Vision LED Light 23.
Device Installation 1. Insert the TF card into the card slot with right direction. 2. Install the device on the wind shield or on the driving instrument board with rack pad. &Use clean and soft cloth to rub away the dirt and moisture on the wind shield or instrument board. 3. Connect the USB port and Car Cigarette thru car charger. 4. Adjust the position for video-shooting. &Press Mic Button or Rec button to make sure the position is right 6.
*Switching the normal/reverse phase of video camera To switch the normal/reverse phase of recording, Long Press "Mic" Button for 3 seconds to switch sensor positive shooting. Long Press "Rec" Button for 3 seconds to switch sensor inverted shooting.
Button Function overview Button Function under Video Recording
Button Function in Playback Mode Technical specifications:
Accessories included Notes: 1) Please insert the TF card before recording. 2)The device default storage time is 2min. When the storage medium is full, it will record from the beginning again and erase over the previously recorded material automatically. It will have 3 seconds pause time, and namely the contents in the 3 seconds will not recorded. 3)Because the DVR is DC5V input, please use the attached car charger.