Operation Manual

ManualsBrandsGemini ManualsCar alarm821

822

821

INSTALLATION AND

USE MANUAL

821

822

INSTALLATION CERTIFICATE

The undersigned qualified installer attests having personally fitted the here described vehicle

security system following the manufacturer instructions.

................................................

..........................................................................................................................

By :

Sold on :

Type of product :

Vehicle :

AC2717/UK REV. 02 - 07/11

Made in Italy

GEMINI Technologies S.p.A.

Via Luigi Galvani 12 - 21020 Bodio Lomnago (VA) - Italia

Tel. +39 0332 943211 - Fax +39 0332 948080

Web site: www.gemini-alarm.com

Reg. n.532-A

UNI EN ISO 9001:2008

Summary of content (8 pages)

PAGE 1
INSTALLATION CERTIFICATE The undersigned qualified installer attests having personally fitted the here described vehicle security system following the manufacturer instructions. By : 822 822 Sold on : Type of product : ................................................ 821 821 Vehicle : .......................................................................................................................... INSTALLATION AND USE MANUAL UK GEMINI Technologies S.p.A.
PAGE 2
UK 1.0 - PRELIMINARY ADVICE............................................................................................. PAGE 03 USER MANUAL 2.0 - OPERATING DESCRIPTION..................................................................................... PAGE 03 2.1 - Complete system arming.......................................................................................... PAGE 03 2.2 - Passive arming.....................................................................................................
PAGE 3
2.6 - SYSTEM DISARMING Press the unlock button on the original radio control of the vehicle; system disarming is confirmed by two siren chirp (if feature has been modified) and two flashes of the turn indicators. An alarm condition will be signalled by five audio signals and five flashes from the turn indicators. See relative paragraph (2.7) for possible causes and signaling. 2.
PAGE 4
INSTALLER MANUAL 7.0 - COMPLETE ELECTRIC DIAGRAM 6.0 - CONNECTOR TABLE 6.
PAGE 5
9.0 - CENTRAL DOOR LOCKING CONNECTIONS TO ARM SYSTEM 8.0 - CONNECTION FOR TURN SIGNALS ACTIVATION 8.1 - CONVENTIONAL CONNECTION LEFT TURN INDICATORS RIGHT TURN INDICATORS ORANGE GEMINI 822 SYSTEM ORANGE WHITE-ORANGE WHITE-ORANGE wire to be connected ONLY if system operates through turn indicators. Central door locking must be connected according to vehicle type (see installation diagrams). The various arming modes are listed below and the connections indicated in the following paragraphs.
PAGE 6
10.0 - SELF-LEARNING OF TURN INDICATORS FLASHES In order to arm/disarm through the turn indicators, the system must learn the vehicle locking(arming)/unlocking (disarming) signals. To do so, connect the WHITE-ORANGE wire to the turn indicators and then proceed as follows: ! Disconnect the 8-way wiring connector from the 8-way system connector. ! Turn ignition key “ON”. ! Connect the 8-way wiring connector to the 8-way system connector; the LED will turn on. ! Turn ignition key “OFF”.
PAGE 7
12.7 - SELECT NEGATIVE IN ALARM FOR HORN/ADDITIONAL SIREN Once activated, this function can arm the output for the siren (continuous sound) or for the horn (intermittent sound). 13.0 - SYSTEM PROGRAMMING EXAMPLE To better understand the programming procedure, here below is an example of the procedure to follow to modify the programmable functions. As mentioned before, ignition turn-on disable the functions, while the push-button confirm it.
PAGE 8
16.0 - TECHNICAL DATA Power supply 12 Vdc Current absorption @ 12Vdc with system armed and LED flashing 15 mA Working temperature range From -30°C to +70°C Engine immobiliser and turn signals relay contact capacity 8 A at 20°C Alarm cycle duration 30 sec. Maximum positive current output when armed (+A) 700 mA Additional siren output current capacity 1A 17.