User manual

00048594.DOC, Version 1.018/23

5. ASSEMBLY AND BASIC ADJUSTMENTS

The headshell, the turntable platter and the counterweight for the tone arm are separately packed to prevent

damage to the turntable during transportation. After unpacking, the parts can be easily assembled. The

packing material should be kept for transportation purposes.

5.1 Mounting the turntable platter

1. Place the rubber driving belt over the bottom of the platter (Fig. 1).

2. Set up the turntable on a plane, stable ground and place the turntable platter on the axle of the turntable

(Fig. 2).

3. Turn the platter by hand until one of the cutouts is near the top right corner and the driving axle of the

motor is visible.

4. The rubber driving belt is visible through the cutouts of the turntable platter. Seize the driving belt and

place it over the driving axle (Fig. 3).

5. Place the supplied slipmat on the turntable platter.

Analog line output

Analog audio output (RCA, left/right) with line level for

connecting an amplifier, a mixer or other units with line

level inputs.

22 Power input

Plug in the supplied power cable here.

Power switch

Press the power switch to turn the unit on and off.