user manual

effect. To restart the song, press the PAUSE button.
REVERSE: When the REVERSE button is pressed, the le
that is currently playing begins to play in reverse mode.
AUX INPUT (MP3): This 1/8” (3.5mm) input accepts any
line-level source including MP3 players. Once a 1/8”
(3.5mm) plug is inserted, the audio from the CD Player is
cancelled out and only the AUX INPUT SOURCE will be
heard out of the main outputs.
VOLUME ROTARY KNOB: The VOLUME rotary knob ad-
justs the volume of the LINE OUT output.
SEARCH: The SEARCH buttons are used to fast-forward
and rewind within a track.
BPM: Press and hold BPM BUTTON to activate TAP tem-
po. Once activated, tap the BPM BUTTON to display the
tempo. Press and hold BPM BUTTON again to deactivate
TAP tempo.
DIRECT ACCESS BUTTONS: The direct access buttons
allow you to inout a track number directly instead of hav-
ing to skip through the tracks individually. Just press the
number or combinations of numbers up to 99 and the
payer will jump to that track after 3 seconds. Press the
track number and press enter to go immediately to the
new track.
TRACK SKIP: The track skip buttons are used to skip to
the next track or go back to the last track.
- If a disc will not play, check to see if the disc was loaded
correctly (label side up). Also check the disc for exces-
sive dirt, scratches, etc.
- If the disc turns but there is no sound, check the cable
connections, if they are ok, check your amplier or re-
ceiver.
- If the CD skips, check the CD for dirt or scratches. Do
not assume that the CD player is defective. Many CD’s
are recorded out of spec and will skip on most or all CD
players. Before sending the unit for repair, try playing a
CD that you are sure plays properly.
CDX-1210
SPECIFICATIONS:
GENERAL:
Type................................................................Compact Disc Player
Disc Type.......................Standard Compact discs (12 cm & 8 cm)
Time Display.........Track Elapsed, Track Remain, or Total remain
Variable Pitch...........................± 16% Slider with Resume Switch
Pitch Bend............................................................± 16% Maximum
Instant Start....................................................Within 0.03 seconds
Installation..........................................................................19” each
Dimensions...........................19” x 3.5” x 10” (482 x 89 x 255 mm)
Weight....................................................................5.51 lbs. (2.5 kg)
AUDIO SECTION:
Quantization..........................1 Bit Linear/Channel, 3 Beam Laser
Oversampling Rate..............................................................8 Times
Sampling Frequency..........................................................44.1 kHz
Frequency Response.............................................20 Hz to 20 kHz
Total Harmonic Distortion...................................Less Than 0.05%
Signal to Noise Ratio..............................................................85 dB
Dynamic Range.......................................................................85 dB
Channel Separatio.....................................................85 dB (1 KHz)
Output Level.......................................................2.0 +/- 0.2V R.M.S.
Power Supply..............................................AC 115/230V, 60/50 Hz
S P E C I F I C A T I O N S A N D D E S I G N A R E S U B J E C T T O
CHANGE WITHOUT NOTICE FOR PURPOSE OF IM-
PROVEMENT.
TROUBLESHOOTING:
6
23
24
25
22
REMOTE CONTROL SECTION:
27
26
28