OPERATIONS MANUAL BEDIENUNGSHANDBUCH MANUAL DEL OPERADOR MANUEL D’INSTRUCTIONS XPM-3000 POWER AMPLIFIER STEREO VERSTÄRKER AMPLIFICADOR DE PODER ESTEREO AMPLIFICATEUR DE PUISSANCE STÉRÉOV (1)
1 2 11 12 1 2 11 12 16 3 3 17 4 5 13 14 4 5 13 14 18 19 16 6 7 8 10 9 230V 15 6 8 7 10 9 120V 15 17 18 20 16 Gemini Sound Products Corp.
120V (3)
230V (4)
Introduction Connections, Controls and Indicators Congratulations on purchasing a Gemini XPM-3000 Power Amplifier. This state of the art power amplifier includes the latest features and is backed by a five year limited warranty. Prior to use, we suggest that you carefully read all the instructions. Rear Panel Note: 120V and 230V units have different types of output connectors on the rear panel.
Operating Instructions one connector touch the adjacent connector, the sound will be distorted, and your amplifier will overheat and go into protection mode. THE AMPLIFIER’S POWER MUST BE TURNED OFF WHEN CHANGING SETTINGS. NOTE (120V only): Two subwoofer output connectors are provided to connect two subwoofers with separate cables. These outputs are wired in parallel and are connected to a mono subwoofer channel (subwoofer output is not directional and does not require a stereo signal).
2. Connect the loudspeakers to the channel A and channel B SPEAKER OUTPUTS (8, 9). THE TOTAL SPEAKER LOAD MUST BE AT LEAST 4 OHMS PER CHANNEL FOR CHANNELS A AND B. If you try to operate at a lower impedance, the amplifier will overheat and then go into protection mode and stop operation until you correct the load conditions. Damping Factor: Channels A and B................................................................>300 @ 8 Ohms Subwoofer Channel.........................................................
SYMPTOM UNIT DOES NOT PRODUCE SOUND. POWER LED DOES NOT LIGHT. CAUSE • POWER SWITCH NOT IN ON POSITION. • MOVE POWER SWITCH TO ON POSITION. • POWER CABLE NOT CONNECTED TO AMPLIFIER OR TO OUTLET. • CONNECT POWER CABLE TO AC SUPPLY. • AC OUTLET NOT ACTIVE. • REPLACE AMPLIFIER MAIN POWER FUSE ON REAR PANEL WITH CORRECT TYPE AND RATING. • MAIN AMPLIFIER FUSE DEFECTIVE. POWER LED LIGHTS, BUT NO SOUND IS PRODUCED BY AMPLIFIER. SOLUTION • NO INPUT SOURCE SIGNAL. • INPUT SOURCE NOT CONNECTED.
In the USA: If you experience problems with this unit, call 1-732-738-9003 for Gemini Customer Service. Do not attempt to return this equipment to your dealer. Parts of the design of this product may be protected by worldwide patents. Information in this manual is subject to change without notice and does not represent a commitment on the part of the vendor. Gemini Sound Products Corp.