User's Manual

page 03
Bluetooth Operation
1. Please ensure that the Bluetooth function has been turned
on in the settings of your Bluetooth enabled device.
2. Turn the speaker on, the indicator light will flash to detect
Bluetooth enabled devices near you and will enter pairing
mode. The indicator light will go off if no Bluetooth devices
are detected within 5 minutes.
3.”GEMLINE SPKR” will appear on the Bluetooth device list,
select “GEMLINE SPKR” to establish pairing. If instructed to
enter a PIN code, please enter ‘0000’.
4. When you want to play audio from another Bluetooth device,
disconnect the speaker from the original device and follow
steps 1-3 to re-pair the speaker with a new Bluetooth
enabled device.
Button Control
• Power On/Off: Short press the Power On/Off button.
• Play/Pause: short press play/pause buttons
• Volume Up/ Volume Down: Short press Volume Up/Down button
• Next Track / Previous Track: Short press Track Up/Next button
page 04
Hands-free phone use
• Answer incoming call: Short press Hands Free Calling button.
• End call: Short press Hands Free Calling button
• Reject incoming call: Hold Power On/Off button for two seconds.
Aux playback operation
1. Turn on the Speaker.
2. Connect the speaker to a smartphone, audio device, or laptop
with the 3.5mm AUX cable(included)
3. The next/previous song, volume, and play/pause buttons can
only be adjusted on the device that is connected through the
3.5mm AUX cable.
Charging the Speaker
1. When the battery is low, please charge via the included USB
cable. The charging time is approximately 2.5 hours and
provides up to 6 hours of continuous operation. Standby time is
approximately 72 hours.
2. The LED indicator light will be red during charging and will turn
blue once it is fully charged.
Back Cover
Specification
Bluetooth specifications：Bluetooth
®
V4.0
Model: Sunapee Bluetooth
®
Outdoor Speaker
Wireless working range: 10M (without obstacles)
Built-in battery: Lithium Battery 2200mAh
USB Recharge voltage: DC 5V
Output power: 3.2W*2
Frequency Response: 100Hz-20kHz
Sensitivity: ≥70dB
Product dimensions: 190*90*46mm
Packing
• Bluetooth
®
Speaker
• USB Charging Cable
• User Manual
• Gift Box
page 05
Warning
1. Do not disassemble, repair, or modify the speaker.
2. Do not place product in or near fire to avoid danger, as it
uses a lithium battery.
3. Avoid storage at extreme temperatures, this can shorten the
battery life and may affect the speaker.
4. Keep the speaker dry and do not store the speaker in damp
areas to avoid damage to the speaker.
5. Avoid dropping the speaker as it may damage the speaker.
Kind Reminder
1. To prolong the speaker’s life span and to avoid hearing
damage, please do not listen to music under high volume for
long periods of time.
2. When an error occurs with the speaker, please turn off the
speaker and restart it to troubleshoot.
3. When the speaker’s power is low, the Bluetooth range may
be affected. Please charge the speaker to avoid disruptions
during use.
page 08 page 09page 06
1. Inspect whether the speaker are
searching for a Bluetooth enabled device to
connect to. If not, restart the speaker.
2. Difficulty in searching and connecting to
a desired device can be affected if multiple
devices are equipped, turned on, and in
range for Bluetooth connectivity. Please
turn off or disable the Bluetooth function
on the other devices.
3. The power of the battery is insufficient,
please recharge the speaker.
1. Inspect the distance between the speaker
and the Bluetooth enabled device, it may
exceed the Bluetooth transmission range.
2. Inspect if there is an obstacle between the
speaker and the Bluetooth enabled device.
3. The power of the battery is insufficient,
please recharge the speaker.
Unable to pair the
speaker with a
mobile device
The music stops from
time to time
page 07
1. Inspect the volume of the connected
speaker or Bluetooth enabled device and
adjust the volume as needed.
2. The power of the battery is insufficient,
please recharge the speaker.
1. The power of the battery is insufficient,
please recharge the speaker.
2. Restart the speaker.
The Bluetooth
®
word mark and logos are registered
trademarks owned by the Bluetooth SIG, Inc. and any use of
such marks by The Gem Group is under license. Other
trademarks and trade names are those of their respective
owners.
The sound is low
or distorted
The Bluetooth
indicator light
remains OFF
Sunapee Bluetooth
®
Outdoor Speaker
100240-001B
Instruction Manual
IC ID: 21530-100240
FCC ID: 2AGR4-100240
Front Cover page 02
Overview
1. Power button
2. Previous track
3. Play, pause, accept/ reject
incoming call
4. Next track
5. Volume down
6. Volume up
7. LED indicator for Bluetooth
connection
8. Microphone
9. 3.5 mm AUX input socket
10. Charging indicator
11. Charging socket
12. Lid
This device contains licence-exempt transmitter(s)/receiver(s) that
comply with Innovation, Science and Economic Development
Canada’s licence-exempt RSS(s). Operation is subject to the
following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including
interference that may cause undesired operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent
appareil est conforme aux CNR d’Innovation, Sciences et
Développement économique Canada applicables aux appareils
radio exempts de licence. L’exploitation est autorisée aux deux
conditions suivantes:
(1) L' appareil ne doit pas produire de brouillage;
(2) L' appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d' en compromettre le
fonctionnement.
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communica-
tions. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment. This device complies with Part 15 of the
FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
1 2 3
9
7
8
12
11
10
4 5 6