User's Manual

Stratos Qi Wireless Charger
IC ID: 21530-100248 Instruction Manual
FCC ID: 2AGR4-100248
1. Micro USB Input Port
2. Wireless Charger Base
3. LED Indicator
For your safety, please read this manual carefully before using
this product.
Applicable Devices
Devices with built-in wireless charging receiver(iPhone8/8Plus,
iPhoneX,Samsung S6,S7,S8,Note8)
Operation:
1.Connect the USB cable with the wireless charger and power
adapter, plug the power adapter into the wall outlet.
2.Put your device on the charging area, try to locate the device
closest to the center of the charging surface.
Indicator status:
1. Product Standby LED Indication: Unit is plugged in and ready
to charge your device: LED Indicator - OFF
2. Device is placed on charging surface: LED Indicator - Blue
3. Error Detection: If there is a foreign object in between the phone
and charging surface the LED Indicator will flash RED, the
charging circuit will disconnect until the foreign object is removed.
4. Note: If the input power from the wall adapter is less than 10W,
charging time will increase due to the lower input power.
OVERVIEW
Standard Accessories
1. Wireless charger
2. User manual
3. USB-A to Micro USB cable
SPECIFICATION
1, Input: 5V/2A
2. Output: 5V/1A (5W)
3, Device Charging distance: <5mm
FCC Statement
This device complies with part 15 and part 18 of the FCC Rules. Operation
is Subject To the following two conditions:
(1) This device may not cause harmful interference, and (2) this devicemust
accept any interference received, including interference that may cause
undesired operation. Changes or modifications not explicitly approved by
the partyresponsible for compliance could void the user's authority
tooperate this equipment.
Note: this equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 and part 18 of the FCC
Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates,
uses and canradiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference toradio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged totry to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
The equipment complies with FCC radiation exposure limits set forth
for an uncontrolled environment. During the operation of device a
distance of 15 cm surrounding the device and 20 cm above the top
surface of the device must be respected.
This device complies with Part 18 of the FCC Rules. This equipment
generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. If this equipment does
cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
● Increase the separation between the equipment and any other
radio device.
● Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
1.Micro USB
Input Port
3.LED Indicator
2.Wireless Charger
Base