2.0CH SOUNDBAR MODEL: VSB2500 FOR TECHNICAL ASSISTANCE & TROUBLESHOOTING PLEASE CALL 1-855-998-4326 OR VISIT WWW.SIBRANDSSUPPORT.
RF Exposure The equipment has been evaluated to meet general RF exposure requirement. The device can be used without restriction.
LOCATION OF CONTROLS 1. STEREO RCA Audio Inputs 2. OPTICAL Input 3. DC Power Input 4. POWER: Press and hold 2 seconds to turn the unit ON or OFF. / SOURCE: Press and release to select the inputs: BT, Aux in, Line in or Optical in. 5. PAIR: Press to begin pairing with a Bluetooth device. 6. LINE IN Input 7. VOLUME: Press to adjust the volume up or down.
REMOTE CONTROL – LOCATION OF CONTROLS 1. POWER: Press to turn the unit ON or OFF 2. BT: Press to switch to Bluetooth Mode. 3. AUX: Press to switch to AUX Mode. 4. MUSIC: Press to switch to the EQ setting optimized for music. 5. MOVIE: Press to switch to the EQ setting optimized for movie sound. 6. TREBLE: Press to adjust the treble up or down. 7. BASS: Press to adjust the bass up or down 8. OPTICAL: Press to switch to Optical mode. 9. MUTE: Press to mute the volume. 10.
REMOTE CONTROL BATTERY INSTALLATION The remote control operates on one CR2025 battery (included). To activate the remote control, remove the insulation tab inserted in the battery compartment. To remove the tab, pull it in the direction of the arrow in the illustration as shown. When the operation of the remote control becomes intermittent or unsatisfactory, replace the original battery with a new 3-volt lithium battery. Replacing the battery in the remote control: 1.
POWER 1. Plug the supplied AC Power Cord into the DC Power Input (3) on the rear of the unit 2. Insert the wall plug of the AC Power Cord into an electrical wall outlet. LED INDICATOR LIGHTS • This Soundbar has 5 Colored LED Indicator Lights on the front of the unit. These lights will show the current status/input of the Soundbar. Refer to the table below for the meaning of each color.
USING THE STEREO RCA INPUTS When connecting two products using an RCA cable, match the colored ports with the same colored connection. Before use, disconnect any cables connected to the LINE IN input (6). 1. Connect the RCA Cable to the STEREO RCA Audio Inputs (1) located on the back of the Soundbar, and to the audio outputs on the Television or other A/V component. 2.
USING THE LINE IN 1. Plug one end of a 3.5mm audio input cable (included) into the LINE IN input (6) on the side of the Soundbar. Before use, disconnect any cables connected to the STEREO RCA Inputs (1). 2. Plug the other end of the cable into the audio output/headphone output on an MP3 player or other audio source. 3. Press and hold the POWER / SOURCE button on side panel (4) or press the POWER button directly on the remote control (1) to turn the Soundbar ON. 4.
TROUBLESHOOTING GUIDE Problem What to do No power Check the connection of the AC/DC adapter between the Soundbar and wall outlet. Check that the volume control is not at minimum No sound Check that the Soundbar & Connected Device are not set to Mute. The remote control won't work Inspect or replace the battery. Make sure there are no obstacles obscuring the front of the Soundbar.
LIMITED ONE-YEAR WARRANTY We warrant this product to be free from defects in material and workmanship under normal use for a one-year period from the original date of purchase from an authorized VIDAO dealer. Should you be missing any of the included accessories or other components (cables, etc.), please contact the Customer Support Center to secure a replacement. It is not necessary to bring the unit back to the store.
©Schoenfeld International Inc., 2017 VSB2500 Rev. 1.
