User's Manual

Use a power drill to make pilot holes for the

plastic anchors

1. Use the supplied wall mounting template to make drill hole marks on the wall. Make

sure the marks are level before drilling.

2. Attach the Spaces to the wall by screwing the supplied flat head screws directly into

the marks that you have made on the wall as shown above.

3. Place the sound bar onto the mounting screw heads. Make sure the sound bar is

attached firmly to the wall.

Mounting the JSBW-210 on wall

1. Use the supplied wall mounting template to make drill hole marks on the wall for the

anchors. Make sure the marks are level before drilling.

2. Use a 1/4” (6.35mm) bit and power drill (Not supplied) to drill holes on the marks.

3. Insert the included plastic anchors into the holes and push in until they are flush with

the wall.

4. Secure the supplied Spaces to the wall by screwing the included flat head screws

into the anchors and tighten until the screw head is 1/4” (6.35mm) away from the

surface of spaces.

5. Place the sound bar onto the mounting screw heads. Make sure the sound bar is

attached firmly to the wall.