Operating Instructions

E-3
a. ON/OFF – Press to turn the set ON; press again to turn the set OFF.
b. COLORS – Change the light color to any on this list by
pressing the button on remote until you reach the desired color.
c. EFFECT - Change the light effect by pressing the button on the remote until you reach the desired light effect.
d. STATIC/MOTION - Press to turn the set to STATIC mode. Press again to turn the set to MOTION mode.
NOTE: The LightShow
TM
setting defaults to red while warming up. It will change to multicolored light after a few
seconds. To select the red-only setting, cycle through the settings using the remote control. See the effects chart for more
information.
NOTES:
1. When using the remote to turn ON your set, there may be up to a 2 seconds delay before the light pattern starts working.
2. To change light patterns it is recommended to wait 2 seconds each time after pressing the Function button until you reach
the desired pattern.
3. If for any reason the signal from the remote (transmitter) to the control box (receiver) hangs up, please turn off and then
restart the power to the set.
4. If a power interruption, the system’s memory keeps the last light pattern displayed.
5. The effective operating distance of the remote is 20’ (6m).
BATTERY USAGE:
See illustration. CR2032 battery included. 1. Keep these instructions for future reference because they contain important
information. 2. May explode or leak and cause burn injury if recharged, disposed of in fire, mixed with a different battery
type, inserted backwards or disassembled. 3. Products that contain batteries should not be disposed of in fire. The batteries
inside may explode or leak. 4. Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries.
5. Do not mix old and new batteries. Replace all batteries of a set at the same time. 6. Use only batteries of the same or
equivalent type as recommended by the manufacturer. 7. Be sure to insert batteries with correct polarities and always follow
manufacturers’ instructions. 8. Remove exhausted batteries from product promptly. 9. Do not short-circuit supply terminals.
10. Remove batteries before storage or extended periods of non-usage. 11. Clean the contacts on the batteries and the
device prior to battery installation. Non-rechargeable batteries are not to be recharged. Rechargeable batteries are not
recommended for use in this product. If rechargeable batteries are being used, however, please follow these guidelines. (1).
Rechargeable batteries should be removed from the product before being charged. (2). Rechargeable batteries should only
be charged under adult supervision.
BATTERY CAUTION:
• Keep this product’s battery out of the reach of small children or pets. If ingested, contact a physician immediately.
• Always purchase the correct size and grade of battery most suitable for the intended use.
• Replace all battery of a set at the same time.
• Clean the battery contacts and also those of the device prior to battery installation.
• Remove battery from equipment which is not to be used for an extended period of time.
• Remove used battery promptly.
• When the remote control begins to lose its sensitivity, check the batteries and replace if necessary.
• Push ‘A’ to open the battery compartment and replace battery.
Ensure the battery is installed correctly with regard to polarity (+ and -)
A